$CS - Configuration Settings
Retrieve and display the configuration settings for the Swarm device ID. These settings are
determined by Swarm for identifying and communicating with each individual device. Since
there are no variable parameters, the correct checksum has been added.
$CS*10
Returns:
$CS DI=<dev_ID>,DN=<dev_name>*xx
Device ID that identifies this device on the Swarm network
Notes:
An ERR response will be generated if the command is not entered exactly as shown with no
additional spaces or characters.
Example:
$CS*10
$CS DI=0x000e57,DN=Modem*10
The Device ID is 0x000e57, and the device is a Modem
November 2021 Swarm M138 Modem Manual - Rev 1.00 36/77
To Next Page
Loading...