Swarm M138 - $RS - Restart Device

$RS - Restart Device
Perform a software cold restart of the device. Since there are no variable parameters, the
correct checksum has been added.
$RS*01
Returns one of:
Value
Description
$RS OK*xx
Command has been accepted and the device will immediately perform a
hardware restart
$RS ERR*xx
Command input error
Notes:
An OK response confirms that the device will successfully restart. No external power cycling is
required.
Example:
$RS*01
$RS OK*25
$Modem BOOT,RESTART*59
Notes:
In order to resolve the DBXTOHIVEFULL error, ensure you’re running firmware version V1.0 or
greater and run the following command.
$RS dbinit*3d
November 2021 Swarm M138 Modem Manual - Rev 1.00 63/77