Need help?Do you have a question about the swepac FB 430 and is the answer not in the manual?
Measurement standards and values for sound pressure and power levels.
Measurement standards and values for hand-arm vibrations.
Compliance with US-EPA stage 2 requirements for exhaust emissions.
Visual warnings and instructions for safe operation and component handling.
Identification labels on the machine indicating manufacturer and specifications.
Identification and brief description of components visible from the left side view.
Identification and brief description of components visible from the right side view.
Procedure for checking and topping up fuel levels.
Procedure for checking engine oil level on different models.
Daily inspection for oil or fuel leaks before operation.
Procedure for checking and cleaning the air filter.
Procedures for checking hydraulic oil levels and components on different models.
Procedure for checking the tension and condition of the V-belt.
Inspection of vibration element for leaks and rubber dampers for condition.
Pre-operation checks before starting the engine.
Step-by-step guide to starting the FB450 model.
Steps for safely stopping the FB450 model.
Steps for safely stopping the FB430 model.
Step-by-step guide to starting the FB510 model.
Steps for safely stopping the FB510 model.
Steps for safely stopping the FB500 model.
Guidance on machine movement, control usage, and operating environment.
Instructions for safely lifting and securing the machine for transport.
Explanation of the electrically heated handle and its activation.
Steps to remove the belt cover and use the hook wrench.
Procedure for loosening the three set screws for belt adjustment.
Steps for replacing the belt by adjusting the centrifugal clutch.
Instructions for tightening the belt using the centrifugal clutch.
Important note to ensure set screws are tightened after adjustment.
How to measure system pressure and expected values.
Guidelines for adjusting hydraulic pressure for optimal operation.
Identification of points for measuring hydraulic system and conversion pressure.
Identification of key components in the hydraulic system diagram.
Explanation of the flow and function of the hydraulic system.
Procedure for measuring hydraulic oil pressure for conversion.
Location of the plug and measuring point for conversion pressure.
Identification of key components in the hydraulic system diagram.
Explanation of the flow and function of the hydraulic system.
Identification of electrical components and their connections in the diagram.
Explanation of the electrical circuits and their functions.
Identification of electrical components and their connections in the diagram.
Explanation of the electrical circuits and their functions.
Identification of electrical components and their connections in the diagram.
Explanation of the electrical circuits and their functions.
Identification of electrical components and their connections in the diagram.
Explanation of the electrical circuits and their functions.
Wiring details for the oil cooler thermostats and relay.
Explanation of the electrical circuit for the oil cooler fan.
How the sensor measures base plate motion and displays compaction progress.
Indicator behavior when starting the machine and engine.
How LED lights indicate surface compression during work.
Details of the manufacturer, Swepac AB.
List of directives the product complies with.
Information on where technical documentation is held.
General| Brand | swepac |
|---|---|
| Model | FB 430 |
| Category | Vibratory rammers & tampers |
| Language | English |
To Next Page