Swiss Bionic Solutions IMRS - Page 6

Page 6 / Operator‘s Guide / iMRS
© Swiss Bionic Soluons Schweiz GmbH / 8834 Schindellegi / 2016
Interference emission mea-
surements
Compliance Electromagnec Environment Guideline
RF emissions acc. to CISPR 11 Group 1 iMRS only uses RF energy for its inter-
nal FUNCTIONING. Its RF emission is
therefore very low and it is unlikely that
neighbouring electronic devices will be
interfered with.
RF emissions acc. to CISPR 11 B iMRS is suitable for use in all establish-
ments including those in living areas
and such that are immediately connec-
ted to the PUBLIC MAINS SUPPLY that
also supplies buildings used for residen-
al purposes.
Emission of harmonic
frequencies according to IEC
61000-3-2
A
Emission of voltage uctu-
aons / icker according to
IEC 61000-3-3
Complies
Guidelines and manufacturer‘s declaraon - electromagnec interference emissions
The iMRS is intended for operaon in an ELECTROMAGNETIC ENVIRONMENT as given below.
The customer or user of the iMRS should ensure that it is operated in such an environment.
Interference
Immunity Tests
IEC 60601 Test
Level
Compliance Level Electromagnec Environ-
ment - Guidelines
Discharge of stac
electricity (ESD)
Acc. to IEC 61000-
4-2
± 6 kV contact
discharge
± 8 kV air
discharge
± 6 kV contact
discharge
± 8 kV air
discharge
Floors should be made of
wood or concrete or covered
in ceramic les. If the oor is
covered with synthec mate-
rial, the relave air humidity
must be at least 30 %.