Swisscom Aton CL317 - Making calls; Making external calls and ending calls; Accepting a call; Calling Line Identification

29
Making calls
Gigaset E500H / Aton CL317 / Schweiz PTT EN / A31008-M2256-F151-1-2X19 / telephony.fm /
Making calls
When the display backlight is
switched off, pressing any key will
activate the backlight. The relevant
key function is performed.
Making external calls and
ending calls
External calls are calls using the pub-
lic telephone network.
~ (Enter phone number) and
u press the talk key c or
u the handsfree key d.
The number is dialled.
You can also first
u press the talk key c or
u the handsfree key d.
(dial tone) and then enter the
number.
To set the earpiece/handsfree vol-
ume during a call, press the side
key ç.
Ending a call/cancelling dialling:
Press the end call key a or place
the handset in the charger.
Accepting a call
The handset indicates an incoming
call in three ways: by ringing, by a
display on the screen and by the
flashing handsfree key d.
You can accept the call on the hand-
set by:
¤ Pressing the talk key c.
¤ Pressing the handsfree key d.
¤ Pressing the display key
§Accept§.
If the handset is in the charger and
the Auto Answer function is acti-
vated (¢ page 42), the handset will
automatically accept a call when
you lift it out of the cradle.
To deactivate the ringer, press the
§Silence§ display key. You can accept
the call as long as it is displayed on
the screen.
Calling Line Identification
When you receive a call, the caller's
number is displayed on the screen,
if the following prerequisites are
met.
u Your network provider supports
CLIP, CLI.
– CLI (Calling Line Identification):
The caller's number is transmit-
ted.
– CLIP (Calling Line Identification
Presentation): The caller's
number is displayed.
u The caller has arranged CLI with
the network provider.
Please note
In the Swisscom ISDN network,
CLIP is transmitted automatically.