Pg. 10 1/2018
Special Switch Functions Control
Bluetooth connection, Sleep mode, and External Trigger functions can be controlled through the switch panel by
pressing and holding the programming switch and then pressing and releasing the desired function switch.
Bluetooth Control:
Bluetooth control can be disabled by pressing and holding the programming switch and pressing
switch 1. The programming led will flash 3 times for indication. Bluetooth connection must be off when
disabling Bluetooth. Bluetooth control can be enabled by pressing and holding the programming switch and
pressing switch 2. The programming led will flash 3 times for indication.
Sleep Mode Control:
Sleep Mode control can be disabled by pressing and holding the programming switch and pressing
switch 3. The programming led will flash 3 times for indication. Sleep Mode control can be enabled by
pressing and holding the programming switch and pressing switch 4. The programming led will flash 3 times
for indication.
The system can be put into sleep mode instantly (no delay) through the switch panel by pressing and holding
the programming switch and pressing switch 5. The programming led will flash 3 times for indication.
For the system to enter sleep mode, Ignition, light, and trigger inputs must be off, all outputs must be off, and
no Bluetooth connection can be present.
Trigger Input Control:
The Trigger controls must first be setup in the App, then they can be turned on and off through the switch
panel as follows:
Trigger 1 control can be disabled by pressing and holding the programming switch and pressing
switch 7. The programming led will flash once for indication. Trigger 1 control can be enabled by pressing
and holding the programming switch and pressing switch 7. The programming led will flash 3 times for
indication.
Trigger 2 control can be disabled by pressing and holding the programming switch and pressing
switch 8. The programming led will flash once for indication. Trigger 2 control can be enabled by pressing
and holding the programming switch and pressing switch 8. The programming led will flash 3 times for
indication.
To Next Page
Loading...
Need help?
General