To Next Page

To Previous Page

1. General Information

1-7

 Do not let the wire harness contact with rotating,

moving or vibrating components as routing the

harness.

 Keep wire harnesses far away from the hot

parts.

 Route wire harnesses to avoid sharp edges or

corners and also avoid the projected ends of

bolts and screws.

 Route harnesses so that they neither pull too

tight nor have excessive slack.

 Protect wires or wire harnesses with electrical

tape or tube if they contact a sharp edge or

corner. Thoroughly clean the surface where

tape is to be applied.

 Secure the rubber boot firmly as applying it on

wire harness.

 Never use wires or harnesses which insulation

has been broken. Wrap electrical tape around

the damaged parts or replace them.

 Never clamp or squeeze the wire harness as

installing other components.

Never Touch

Never too tight

Never clamp or

squeeze the wire

harness

To this chapter contents

Questions and Answers:

Need help?

Do you have a question about the Sym JOYMAX 250 and is the answer not in the manual?

Sym JOYMAX 250 Specifications

General