Sym JOYMAX 250 User Manual

3. Lubrication System
3-7
Gear Oil
Gear Oil Change
Remove oil join bolt.
Remove drain bolt and drain gear oil out.
Install the drain bolt after drained.
Torque value: 1.1~1.5kgf-m
Make sure that the drain bolt washer can be
re-used.
Add oil to specified quantity from the join hole.
Gear Oil Quantity: 170c.c. when replacing
Make sure that the join bolt washer can be
re-used, and install the bolt.
Torque value: 1.0~1.4kgf-m
Start engine and run engine for 2-3 minutes.
Turn off engine and make sure that oil level is in
correct level.
Make sure that no oil leaking.
To this chapter contents
Gear oil join bolt
Gear oil drain bolt

Sym JOYMAX 250 Specifications

General

Displacement	249.4 cc
Fuel System	Electronic Fuel Injection
Cooling System	Liquid cooled
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Seat Height	770 mm
Dry Weight	182 kg
Width	760 mm
Height	1, 420 mm
Wheelbase	1, 550 mm
Engine Type	4-stroke, Single cylinder
Transmission	CVT
Fuel Capacity	12 L
Length	2190 mm