Symbol LS4278 - RTS Line State; Beep on <BEL

LS4278 Product Reference Guide7-16
Host Serial Response Time-out (continued)
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High RTS line state.
Beep on <BEL>
When this parameter is enabled, the scanner issues a beep when a <BEL> character is detected on the RS-232 serial line. <BEL> is
issued to gain a user's attention to an illegal entry or other important event.
High: 7.5 sec
Maximum: 9.9 sec
*Host: Low RTS
Host: High RTS
Beep On <BEL> Character
(Enable)
*Do Not Beep On <BEL> Character
(Disable)