Synaccess netBooter Series - Serial Console Port Configuration Menu; Figure 24 - Serial Port Parameter Entry Table

User’s Manual
Synaccess Networks, Inc. www.synaccess-net.com (760) 930 – 0473 Page 33 of 46
Use the command “emailvbs x” to set to mail verbose mode. In verbose mode, the system
displays detailed information while sending and receiving emails. It is helpful while you are
setting up your email accounts.
“emailvbs 0” turns the verbose mode off.
“emailvbs 1” sets the system to level 1 verbose mode, in which high level emailing
activities are displayed.
“emailvbs 2” sets to the system to level 2 verbose mode, in which detailed emailing activities
are displayed.
Use command “emailget” to check incoming emails immediately.
Use command “emailsend” to send a test mail immediately.
5.5 Serial Console Port Configuration Menu:
This section describes serial console port configuration and operating settings.
Serial Console Port configuration starts with the following menu:
Figure 24 – Serial Port Parameter Entry Table
************************************************************
* *
* *
* "Master" Port Configuration Menu *
* *
* *
************************************************************
>
> 1) Baud rate..................................9600
2) Data bits:(7 or 8).........................8
3) Stop bits(1 or 2)..........................1
4) Parity(1-Even,2-Odd,3-None)................3
5) Flow control(1-hardware,2-None)............2
6) Port name..................................Master
7) Save:
8) Quit:
>Please select a parameter to change: