59
PROGRAMMING
Menu Level 3: Conguraon
See the previous page for instrucons on how to access menu level 3.
This is the conguraon screen.
Pressing a line buon will ash the rst adjustable value. Pressing it again will ash the next, and so on.
Model codes: H = MVP Hydra, S = MVP Single pump, C is not used at this me.
Bypass and boost values should reect whether or not the machine has the appropriate hardware installed,
not whether they are being used. Since bypass hardware is only compable with Hydras, the value will
change to “N” if the model value is not “H”
The serial number entered on this screen is shown during the machine boot-up sequence.
If any sengs on this screen are changed, the machine will require a restart upon exing this screen. When
prompted, press the corresponding line buon to restart or to cancel and revert to the previous sengs.
Machines with rmware version 2.62 and above will display the Conguraon screen as in the picture
above. This updated conguraon includes model SX0 for the S-Series machines.
Line 3 includes PRG for the purge funcon which is a standard funcon of S-Series machines only. For MVP
Series, PRG should be programmed as “N”.
To cycle to the next display screen or to lock in changes and restart, press the down buon.
To Next Page
Loading...
Need help?
General
