Synesso MVP Hydra

61
PROGRAMMING
Menu Level 3: Peak Current Limit
The peak current limit feature is made available with rmware version 2.64. This is an oponal electrical
conguraon that, when enabled, will allow the machine to be programmed to operate at a lower maxi-
mum amperage than the standard conguraon. Note that this is not an energy saving feature. It is in-
tended to meet the needs of electrical infrastructures outside the USA that dier from the standard-
congured machine specs.
Line 2 indicates that the feature is disabled. To enable the feature, a machine specic PIN must be en-
tered on Line 4.
Contact Synesso™ Technical Support in order to request a PIN and instrucons. Synesso™ approval is
required in order to ulize this feature.
Menu Level 3: Factory Diagnoscs
The factory diagnoscs screen is an un-editable screen for factory use only. This screen can be viewed on
rmware versions 2.52 and above.
To cycle to the next screen, press the down buon.