Synesso MVP Hydra

62
A full factory reset can be achieved by pressing the line 3 buon, then either the up or down arrow.
This opon will undo ALL changes that have been made to the machine. This includes the Synesso™ pro-
grammed osets, serial number and machine conguraon informaon.
It is highly recommended that you make note of all Synesso programmed sengs before doing a full reset
of the machine.
RESET CANNOT BE UNDONE. PLEASE BE CAREFUL!
Menu Level 3: Full Reset
The proporonal-integral-derivave (PID) controller is a sequence of algorithms using a few nely tuned
parameters to achieve and maintain a set temperature in each tank.
Synesso™ strongly recommends AGAINST altering these values.
The default values are shown in the picture above.
To cycle to the next screen, press the down buon.
Menu Level 3: PID Tune
PROGRAMMING