getting started
14
SYNRAD OEM v40 Operator’s Manual Version 4
Unpacking
The Unpacking section includes subsections:
■ Incoming inspection
■ Packaging guidelines
Incoming inspection
Upon arrival, inspect all shipping containers for signs of damage. If you discover shipping damage,
document the damage (photographically if possible), then immediately notify the shipping carrier and
SYNRAD.
The shipping carrier is responsible for any damage occurring during transportation from SYNRAD, Inc. to
your receiving dock.
Packaging guidelines
■ To prevent equipment damage or loss of small components, use care when removing packaging materi-
als.
■ Save all shipping containers and packaging materials, including covers and plugs. Use these special-
ized packing materials when shipping the laser to another location.
■ After unpacking, review the Inventory section and verify that all components are on hand.
■ When packing a laser for shipment, be sure to remove all accessory items not originally attached to
the laser including beam delivery components, cooling tubing, ttings, etc.
■ Refer to the Packaging Instructions drawing in the Technical Reference chapter for information on
packaging a v40 for shipment using SYNRAD-supplied packaging materials.
■ When shipping water-cooled lasers, remember to drain all cooling water from the laser and then cap
open ttings to prevent debris from entering the coolant path.
■ Do not lift or support the laser using the cooling ttings; lift the laser by the mounting feet or
baseplate only.
To Next Page
Loading...
Need help?
General
