EasyManuals Logo

Synrad Firestar V Series User Manual

Synrad Firestar V Series
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
technical reference
79
SYNRAD OEM v40 Operator’s Manual Version 4
v40 general specications
Table 4-7 Firestar v40 general specications
Parameter Firestar v40
Output Specications
Wavelength
............................................................10.57–10.63 microns
Power Output
1, 2
...................................................40 Watts
Power Stability
3
.....................................................± 5%
Power Stability
4
.....................................................± 3%
Mode Quality ...........................................................TEM
00
, M
2
< 1.2
Beam Waist Diameter (at 1/
e2
)
5
........................2.5 mm ±0.5 mm
Beam Divergence, full angle (at 1/
e2
)
5
...........< 7.0 mrad
Ellipticity ...................................................................< 1.2
Polarization ..............................................................Linear, horizontal
Extinction ratio ........................................................> 100:1
Rise Time ...................................................................< 100 µs
Modulation (Optical response) .........................up to 25 kHz
Input Specications
Power Supply
Voltage .............................................................30 VDC
Maximum Current ........................................24 A
Typical .......................................................18 A
Command Input Signal
Voltage .............................................................+3.5 to +6.7 VDC
Current ..............................................................10 mA @ +6.7 VDC
Frequency
6
.....................................................DC–25 kHz
Duty Cycle .......................................................0%–100%
Logic Low State (Vmin–Vmax) .................0.0 to +0.8 VDC
Logic High State (Vmin–Vmax) .................+3.5 to +6.7 VDC
Cooling Specications ..........................................(Air-cooled) ............................................. (Water-cooled)
Maximum Heat Load, laser ................................700 Watts ................................................. 700 Watts
Minimum Flow Rate .............................................140 CFM per fan .................................... 1.0 GPM, < 60 PSI
Rear air-cooled ................................................> 300 CFM ...............................................N/A
Coolant Temperature ...........................................< 40 °C, ambient ................................... 18 °C–22 °C
* Specications subject to change without notice.
Typical. Actual wavelength range may vary from 10.2–10.8 µm.
1 This power level is guaranteed for 12 months regardless of operating hours.
2 Minimum 30 VDC input voltage to obtain guaranteed output power.
3 From cold start (guaranteed).
4 After two minutes (typical).
5 Measured at laser output.
6 Tested at 5 kHz.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Synrad Firestar V Series and is the answer not in the manual?

Synrad Firestar V Series Specifications

General IconGeneral
BrandSynrad
ModelFirestar V Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals