Synrad Firestar V Series - Operational Flowchart

maintenance/
troubleshooting
92
SYNRAD OEM v40 Operator’s Manual Version 4
Troubleshooting
Operational owchart
The owchart gure below illustrates Firestar’s start-up sequence.
Figure 5-1 Operational owchart
Ye s
No
INT
(Remote Interlock)
indicator Green?
TMP
(Temperature)
indicator
Green?
SHT
(Shutter) indicator
Blue?
RDY
(Ready) indicator
Ye llow?
RDY
(Ready) indicator
Yellow?
Apply interlock signal
to Remote Interlock input
or install factory-supplied
Quick Start Plug
Water-Cooled:
Check that cooling water
is flowing through laser
and that coolant temp
is within specified limits
Apply shutter open
signal to Shutter Open
Request input or install
factory-supplied Quick
Start Plug
Cycle Keyswitch from ON
to OFF and then
back to ON
(on OEM lasers,
cycle DC power)
Ensure that manual
Shutter Switch (if
equipped) is set
to Open
Apply PWM Command
signal to laser
Tu rn Keyswitch
(if equipped)
to ON
Apply 30 VDC
power to laser
LASE indicator
illuminates Red to
indicate laser output
Laser Start Sequence
Ye s
Ye s
Ye s
No
No
No
Ye s
No
Air-Cooled:
Check that cooling fans
are clear of debris
and are providing the
specified airflow