Synrad Firestar V Series User Manual

getting started
16
SYNRAD OEM v40 Operator’s Manual Version 4
Inventory
Contents description
Each item listed in Table 1-1 is described below.
SYNRAD Firestar v40 Laser – for cutting, welding, drilling, and marking a wide variety of products and
materials.
Quick Start Plug (except SAB models) – connects to Firestar’s User I/O connector. Jumpers are built into
the plug to enable Firestar’s shutter and remote interlock circuits for initial start-up and testing.
Cooling Tubing (water-cooled only) – carries cooling water from the chiller to the laser and back. This
black polyethylene tubing is 1/2" O.D. by 30 feet and must be cut to length.
Mounting Bolts – 1/4–20 × 5/8" bolts fasten Firestar to your mounting surface.
Firestar v40 Operator’s Manual – provides setup, operation, and maintenance information for your Firestar
v40 laser.
Spare Fuse (not shown) – fast blow 25 A fuse protects Firestar’s internal circuitry.
Final Test Report (not shown) – contains data collected during the laser’s nal pre-shipment test.

Synrad Firestar V Series Specifications

General

Brand	Synrad
Model	Firestar V Series
Category	Measuring Instruments
Language	English