Sys Tec Electronic USB-CANmodul - Checking the Device Installation; Figure 1: Device Manager with the USB-Canmodul

Getting Started

SYS TEC electronic GmbH 2001 L-487e_6
11
2.1.3 Checking the Device Installation
You can check to see if the module is logged-on properly to the host-
PC in the following way:
•
Highlight the icon “My Computer” on the desktop and click the
right mouse key.
•
A pop-up menu appears. Click on “Properties”. The dialog box
“System Properties” appears.
•
Choose the tab “Device Manager” at the top. Click on the pull-
down menu “Universal Serial Bus Controller”. If the device
“Systec USB-CANmodul (usbcan.sys)
”
is shown in the list, the
new USB device has been detected properly. This is shown in the
figure below:
Figure 1: Device Manager with the USB-CANmodul