EasyManuals Logo

t.a.c. Xenta OP User Manual

t.a.c. Xenta OP
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
TAC Xenta OP Handbook Foreword
4 (36), 0-004-7506-4 (EN) TAC AB, 2001-08-08
Copyright © 2001 TAC AB.
This document, as well as the product it refers to, is only intended for licensed users of the product and the document.
TAC AB owns the copyright of this document and reserves the right to make changes, additions or deletions.
TAC AB assumes no responsibility for possible mistakes or errors that might appear in this document.
Do not use the product for any other purposes than those indicated in this document.
Only licensed users of the product and the document are permitted to use the document or any information therein.
Distribution, disclosure, copying, storing or use of the product, the information or the illustrations in the document
on the part of non-licensed users, in electronic or mechanical form, as a recording or by other means, including
photocopying or information storage and retrieval systems, without the express written permission of TAC AB, will
be regarded as a violation of copyright laws and is strictly prohibited.
TAC Xenta®, TAC Menta® and TAC Vista® are registered trademarks of TAC AB in Sweden and other countries.
All other brand names are trade marks of their respective owners.
Revisions list
Art no Comments Editor Date
0-004-7506-0 First version. KW 1996-08-08
0-004-7506-1 This document has been revised to cover TAC Xenta v 3.0. KW 1997-09-01
The following major changes have been made:
- The Chapter contents have been rearranged.
- A new chapter has been added, showing how to communicate
with Xenta 100 and how to reach the Network Variables.
Trade mark change from TA to TAC. KW 1998-06-11
0-004-7506-2 This document has been revised to cover TAC Xenta v 3.2. KW 1999-01-26
0-004-7506-3 The explanation of the OP communication mode has been KW 2000-08-08
expanded (section 2.6).
The OP/RU model with Cyrillic characters added.
0-004-7506-4 The de-installation procedure has been clarified (section 2.7). KW 2001-08-08
Switching between SI and I-P units has been added to section 3.2.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the t.a.c. Xenta OP and is the answer not in the manual?

t.a.c. Xenta OP Specifications

General IconGeneral
Brandt.a.c.
ModelXenta OP
CategoryControl Panel
LanguageEnglish