75
76
Customer Service Toll Free: 833.3TACTILE (833.382.2845)
5. Unzip your forearm zipper, so your hand can remain free once
you put on your combined vest and arm garment.
6. Slide your vest garment on as you would a jacket, starting with
the aected arm. Identify both ends of the front zipper, and zip
your vest garment closed using the front zipper pull. Put your
thumbs through the black handle loops at the front bottom of
your vest garment, and push downward to adjust vest garment
positioning (Figure 7.2.p.).
FLEXITOUCH PLUS with ComfortEase
7. Zip your arm garment closed (Figure 7.2.q.).
8. Locate the tab labeled ‘E’ at your armpit, and unfold and attach
it to snugly conform your arm garment around your biceps.
Smooth the inner layer of fabric, if needed (Figure 7.2.q.).
NOTE: To contour your arm garment, ensure your shirt underneath
your arm garment is not bunched up; pull it down, if necessary.
9. Unhook the tab labeled ‘5’ from your arm garment, and pull
inward until you achieve a snug – but not tight – t. Check to
see if you can slide two ngers under tab ‘5’ when attached.
Repeat for the tabs labeled ‘6’, ‘7,’ and ‘8,’ moving down your
arm garment toward your hand and smoothing out the inner
fabric between each tab adjustment. Your ngertips should
remain fully enclosed within your
arm garment (Figure 7.2.q.).
NOTE: Your arm garment
should not feel as tight
as a compression sleeve.
You are now ready to
begin your treatment
session. See Chapter 9
for further instructions.
Figure 7.2.p.
Figure 7.2.q.
To Next Page
