Appendix 1 list of Parameters State 16.11.15
Misprints and technical changes reserved Page 5
Reference Speed Selection
[00] Preset Speed ... [08] Positioning
The definition of the required rotational speed setpoint source can be selected as follows:
The number in brackets corresponds with the priority of the set function. (1=highest priority)
This means, for example, if “analog input” is selected and the “slave-function” is then turned on, the analog
input is deactivated and the incremental slave setpoint is activated.
The current reference source is shown in Par. 567 (current source of reference rotational speed)
Is also valid for manual inputting of the setpoint via
the U-drive Manager
Digital/analog PCB (Option)
To Next Page
Loading...
Need help?
General
