156 Part G: Alarms © Tait Electronics Limited December 2007
Disabling Unwanted Alarms
You can disable any of the base station’s alarms. Some alarms may not be
appropriate for your system. For example, the Balanced input low alarm is only
helpful if the absence of a line input indicates a system failure.
If you disable an alarm, it does not function in the Service Kit, appear in the
alarm log, or turn on the control panel LED. It is not sent to the Alarm Center
or to a syslog collector. However, Task Manager tasks with that alarm as an
input are still processed.
To disable unwanted alarms
1. Select Configure > Alarms > Alarm Control.
2. Clear the check boxes of the alarms to be disabled.
3. Click OK.
To Next Page
Loading...
Need help?
General
