86 Operation TB9100/P25 CG/P25 TAG Installation and Operation Manual
© Tait Limited March 2014
PA
The indicator LEDs on the PA are visible through a slot in the front panel.
Indicator LEDs These LEDs provide the following information about the state of the PA:
■ steady green - the PA is powered up
■ flashing green - the PA has no application firmware loaded; you can use
the CSS to download the firmware
■ flashing red - one or more alarms have been generated; you can use the
CSS to find out more details about the alarms.
The alarm LED will flash whenever an alarm is generated, whether or
not this alarm has been disabled in the CSS.
Figure 4.4 Indicator LEDs on the PA
b
indicator LEDs
b
5/50W PA
100W PA
To Next Page
Loading...
Need help?
General
