136 TOPA-SV-024 Test Unit TM8100/TM8200 Accessories Manual
© Tait Electronics Limited August 2005
18.2.4 Rx / Tx/PTT switch
This 2-way toggle switch is used to switch between receive and transmit mode.
■ When set to Rx, the PTT line is switched to high impedance.
■ When set to Tx/PTT, the PTT line is pulled to ground.
18.2.5 Speaker / Radio / Load switch
This 3-way toggle switch is used during receive audio tests to switch the audio
to the test unit speaker (Speaker), to the radio’s internal speaker (Radio) or to
a dummy load consisting of R1 and R2 (Load).
Note This switch does not disconnect the radio’s internal speaker on
M8100 radios with a user interface. If the switch is set to Speaker
or Load, this simulates an external speaker being connected in par-
allel to the radio’s internal speaker. TM8000 radios without a user
interface do not have an internal speaker.
With all settings, a low level audio signal is available for testing through
the SINAD port.
Tait Orca portables ■ When set to Speaker, only the speaker of the test unit is active.
■ When set to Radio, only the speaker of the Tait Orca portable is active.
■ When set to Load, no speaker is active. The audio signal is terminated in
the test unit dummy load.
TM8000 radios with
user interface
■ When set to Speaker, the speakers of the test unit and the TM8000 are
both active. The speaker of the TM8000 cannot be disconnected.
■ When set to Radio, only the speaker of the TM8000 is active.
■ When set to Load, the TM8000 speaker remains active.
To Next Page
Loading...
