Tait tm8200 Accessories Manual

14 Safety and Servicing Information TM8100/TM8200 Accessories Manual
© Tait Electronics Limited August 2005
1.4 Regulatory Information
Any modifications you make to this equipment which are not authorised by
Tait Electronics Ltd may invalidate your compliance authority’s approval to
operate the equipment.
1.5 PCB Information
All PCBs are identified by a unique 10 digit IPN (internal part number)
which is printed onto the PCB (usually on the top side), as shown in the
example below:
The last two digits of this number define the issue status, which starts at 01
and increments through 02,03, 04, etc. as the PCB is updated. If the PCB
information contained in a section of this manual does not match the PCB
number printed on your board, contact Technical Support (refer to “Tait
Contact Information” on page 2).
Figure 1.3 Identifying Pozidriv and Philips screws and screwdrivers
internal notches
Pozidriv
Philips
no special
markings
“star” markings
between slots
slots with
parallel sides
slots with
tapered sides
driving flutes with
parallel sides
driving flutes with
tapered sides
ridges between
driving flutes

Tait tm8200 Specifications

General

Operating Temperature Range	-30°C to +60°C
IP Rating	IP54
Channel Spacing	12.5 kHz, 25 kHz
Battery Life	N/A (Mobile Radio)
Frequency Range	136-174 MHz, 400-470 MHz