12 Receiver Specifications TM9400 Specifications Manual
© Tait Limited November 2016
2 Receiver Specifications
This chapter compares the performance of the receiver in a TM9400 radio
with receiver requirements specified by ETSI and TIA.
Where an ANSI/TIA or ETSI EN 300 113 test method was used to measure
TM9400 performance, this is indicated in parentheses. Where the ETSI test
method EN 300 086-1 was used, no test method is named. Please see also
the footnotes to the tables.
Notice The TM9400 specifications in this manual are typical perfor-
mance figures that are intended only to provide guidance. They are sub-
ject to change without notice and shall not form part of any contract. To
establish whether the radio meets the regulatory requirements that apply
to you, please contact your regional Tait office.
For important information about how radio performance figures were
derived, see Chapter 1 Introduction.
To Next Page
Loading...
Need help?
General
