Tait TP9300 User Manual

130 Operating in trunked mode
The message Do not disturb activated appears
on the display. Your radio will now ignore all
incoming calls.
2 To deactivate the do-not-disturb function, press
the do-not-disturb function key again.
The message Do not disturb deactivated
appears on the display.
Using the Main menu
1 Press Menu and select Radio Settings >
Call Settings > Do not disturb.
2 In the Do not disturb menu, choose On.
3 Press Select.
The message Do not disturb activated appears
on the display. Your radio will now ignore all
incoming calls.
Switching to conventional
channels or conventional
groups
You may be able to dial conventional channels or
groups, using 101 to 110. The channels or groups
called using these numbers are programmed for your
radio.
To call a conventional channel or group:
1 Dial the number for the channel or group you wish
to call.
2 Press Send or the # or PTT key.
Your radio switches to the conventional channel
programmed for that number.

Tait TP9300 Specifications

General

IP Rating	IP67
Frequency Bands	VHF: 136-174 MHz, UHF: 400-470 MHz
Power Output	VHF: 5W; UHF: 4W
Battery Life	Up to 14 hours
Channel Spacing	12.5 / 25 kHz
Operating Voltage	7.4V
Battery Capacity	2000 mAh
Digital Protocol	DMR Tier II
RF Output Power	VHF: 5W; UHF: 4W
Operating Temperature	-30°C to +60°C
Encryption	AES-256
GPS	Yes
Display	High-resolution LCD