Tait TP9300 User Manual

90 Operating in conventional mode
You can also delete the selected call or messages, or
delete all queued calls and messages.
Call alert
This feature is available for DMR digital channels only.
You can let another radio user know that you want to
talk to them by sending them a call alert page. When
the other radio user receives the call alert page, they
can call you back when it is convenient.
If you are on a DMR conventional channel, you can
send a call alert to any other radio on the same DMR
conventional channel.
To send a call alert page:
1 Press Menu and select Services > Call alert.
You can also send a call alert from the Options
> Services menu of an address book entry.
2 If an address book is configured, you can select to
either dial a number or show the address book.
Otherwise a preset list of radios will appear.
3 Select the radio you want to page.
4 Press Send to.
A message appears in the display.
Send using
Dialed number
Address book
Back Select
Call alert
Richard
John
Send toCancel
Sending page
to Richard
Cancel

Tait TP9300 Specifications

General

IP Rating	IP67
Frequency Bands	VHF: 136-174 MHz, UHF: 400-470 MHz
Power Output	VHF: 5W; UHF: 4W
Battery Life	Up to 14 hours
Channel Spacing	12.5 / 25 kHz
Operating Voltage	7.4V
Battery Capacity	2000 mAh
Digital Protocol	DMR Tier II
RF Output Power	VHF: 5W; UHF: 4W
Operating Temperature	-30°C to +60°C
Encryption	AES-256
GPS	Yes
Display	High-resolution LCD