Tait TP9300 User Manual

Charging and caring for batteries 157
About the chargers
Unless otherwise indicated, the charging advice and
instructions in this document apply to all chargers.
The following chargers are available for your Tait
radios and batteries:
Chargers for intrinsically safe (IS) and non-
incendive (NI) batteries contain circuitry for the
protection of IS/NI batteries. These chargers
are marked with an IS circle logo
.
IS/NI radios are also marked with an IS circle
logo .
IS/NI batteries are identified on their labels.
IS/NI batteries can only be charged in the chargers for
IS/NI batteries. However, all chargers can charge
non-IS/NI batteries.
Part number range Designation
T03-00012-xxxx Desktop charger for
non-IS/NI batteries
T03-22011-Bxxx Desktop charger for
IS/NI batteries
T03-00013-xxxx 6-way charger for
non-IS/NI batteries
T03-22011-Cxxx 6-way charger for
IS/NI batteries
T03-00014-AAAA Battery-only vehicle
charger for non-IS/
NI batteries
T03-00014-Bxxx Vehicle charger for
non-IS/NI batteries
T03-22011-Dxxx Vehicle charger for
IS/NI batteries

Tait TP9300 Specifications

General

IP Rating	IP67
Frequency Bands	VHF: 136-174 MHz, UHF: 400-470 MHz
Power Output	VHF: 5W; UHF: 4W
Battery Life	Up to 14 hours
Channel Spacing	12.5 / 25 kHz
Operating Voltage	7.4V
Battery Capacity	2000 mAh
Digital Protocol	DMR Tier II
RF Output Power	VHF: 5W; UHF: 4W
Operating Temperature	-30°C to +60°C
Encryption	AES-256
GPS	Yes
Display	High-resolution LCD