Tait TP9300 User Manual

Operating in conventional mode 73
(Depending on how your radio is programmed, you
may be able to use a function key, the scroll keys
or left selection key to select a group.)
2 In the Channels menu, scroll through the list of
channels and groups until the group you want
appears.
3 Press Select, and the programmed scan or voting
group is now shown on the display. The scanning
icon appears on the display.
Dialing a scan or voting group
This feature is only available for radios with
alphanumeric keys.
Dialing a scan or voting group may be available from
the radio’s idle display but is always available while in
the Channels menu.
To dial the group number from the default display:
1 Dial the number associated with the scan or voting
group using the alphanumeric keys.
2 Press Select, and the programmed scan or voting
group is now shown on the display. The scanning
icon appears on the display.
SelectBack
Channels
Channel 9
Scan 1
Scan 1
MenuChannels
12
SelectClear

Tait TP9300 Specifications

General

IP Rating	IP67
Frequency Bands	VHF: 136-174 MHz, UHF: 400-470 MHz
Power Output	VHF: 5W; UHF: 4W
Battery Life	Up to 14 hours
Channel Spacing	12.5 / 25 kHz
Operating Voltage	7.4V
Battery Capacity	2000 mAh
Digital Protocol	DMR Tier II
RF Output Power	VHF: 5W; UHF: 4W
Operating Temperature	-30°C to +60°C
Encryption	AES-256
GPS	Yes
Display	High-resolution LCD