1-29
SAFETY
Prohibit access by unauthorized persons
PRECAUTIONS ON MAINTENANCE
Do not allow unauthorized personnel in the
work area while working. Be careful when
grinding, welding or using a hammer. You
could be injured by flying debris from the
machine.
Prepare work area
• Select a firm, level work area. Make sure
there is adequate light and, if indoors,
ventilation.
• Clear obstacles and dangerous objects.
Eliminate slippery areas.
Cautions on working on top of the
machine
• Before performing maintenance on the top
of the machine, clean the place you will
work on and observe the following to
prevent falling.
· Do not spill oil or grease.
· Do not leave tools scattered around.
· Watch your step when walking.
• Never jump down from the machine. Use
the steps and handrails when climbing up
and down the machine, and always
support your body at three points with your
hands and feet.
• Do not stand on the dozer blade and
perform maintenance work. Doing so is
dangerous because of the unsteady
foothold. Use the work bench.
Always keep the machine clean
• Clean the machine before performing
maintenance.
• Stop the engine before washing the
machine. Cover the electrical parts so that
water cannot enter. Water on electrical
parts could cause short-circuits or
malfunctions. Do not use water or steam to
wash the battery, electronic control
components, sensors, connectors or the
operator’s compartment.
AG7A068
To Next Page
Loading...
Need help?
General
