EasyManuals Logo

Takeuchi TB1160W User Manual

Takeuchi TB1160W
297 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
2-39
CONTROLS
CONTROL CONSOLE
7. Automatic deceleration switch
When the ON side of the switch is pressed,
the deceleration lamp in the Multi-information
display flashes. This flashing stops when the
deceleration function starts working, and the
lamp remains lit while in the deceleration
mode. The engine speed automatically drops
to low idle (deceleration mode) four seconds
after the control levers are set to neutral, to
reduce fuel consumption. Moving the control
levers will cause the speed to return to the
original engine speed.
Switching from the deceleration button to the
auto-deceleration switch will first return to
the engine speed set with the throttle
controller. Then, the engine will automatically
enter the deceleration mode (low idling) if the
control levers are not operated within four
seconds.
BUTTONS
8. Hazard button
Press this button to turn on the
hazard lamp. The turn signal indicator
lamp also turns on.
Note: This switch can be operated even
when the power is turned off.
9. Attachment lock button
When traveling on a road, be sure to lock
the working equipment. If any of the
controls is accidentally touched when it is
unlocked, the machine may suddenly
move and cause serious injury or death.
This button is used when traveling on
a road. Pressing this button will turn
on the button lamp, indicating that
the operations of the hoe attachment,
slewing, auxiliary circuit and blade
(outriggers) are locked. The attachment lock
indicator lamp lights up on the display.
Pressing this button again will turn off the
lamp and the indicator lamp, indicating that
the locking is released.
10. Travel pedal button (foot accelerator
mode)
Pressing this button while the brake
pedal is depressed will turn on the
button lamp, indicating that the
engine RPM can be controlled by operating
the travel pedal. The travel pedal indicator
lamp lights up on the display. Turn on this
switch when traveling. This button can be
used in the digging mode.
Pressing this button again will turn off the
lamp and the indicator lamp, indicating that
the foot accelerator mode is canceled.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Takeuchi TB1160W and is the answer not in the manual?

Takeuchi TB1160W Specifications

General IconGeneral
BrandTakeuchi
ModelTB1160W
CategoryExcavators
LanguageEnglish

Related product manuals