Takeuchi TB1160W - Light Switch; Lift Overload Warning Switch (if Equipped)

2-45
CONTROLS
SWITCHES
LIGHT SWITCH
When this switch is turned while the starter
switch is at ON, the lights turn on as follows:
OFF ......... Off
ON .......... Switch lamps, front light, boom
light, side lights and tail lamps will
be lit. (switch lamp is lit)
LIFT OVERLOAD WARNING SWITCH (IF
EQUIPPED)
If the overload is not removed after the
overload warning horn is sounded, the
machine may tip over. If the horn starts
sounding, stop operating the machine
and lighten the load.
If a weight greater than the lifting capacity is
applied or lifted, the overload warning device
is activated and the horn sounds. (When the
lift overload warning switch is turned on.)
OFF ......... Off
ON .......... On