Takeuchi TB1160W - Tool Box; Fuel Filler Port

2-5
CONTROLS
TOOL BOX
Opening
1. Remove the cover (1) from the knob.
2. Insert the starter key and turn it
counterclockwise to unlock the tool box.
3. Open the cover.
Closing
1. After using tools, store them back in the
tool box.
2. Close the cover (1).
3. Insert the starter key and turn it clockwise
to lock the tool box.
4. Install the cover (1) on the knob.
COVERS
FUEL FILLER PORT
• Never jump down from the machine.
Use the steps and handrails when
climbing up and down the machine, and
always support your body at three
points with your hands and feet.
• Do not smoke and keep away from heat
or flame while filling the fuel tank.
• Fill the fuel tank in a well ventilated
place, with the engine turned off.
• Clean up spilled fuel immediately.
• Do not fill the fuel tank to capacity.
Allow room for oil expansion.
• Securely tighten the fuel filler cap.
Opening
1. Open the cover, insert the key and turn it
clockwise to unlock.
2. Turn the fuel filler cap counterclockwise
and remove it.
Closing
1. Install the fuel filler cap to the fuel filler
port, and then turn the cap clockwise to
close it.
2. Lock the fuel filler cap.