Takeuchi TL250 User Manual

CONTROLS
Switches
Travel Speed Button
U1 B009
Press this button to set the travel speed to
2nd speed (high speed) while travel speed
lamp lights. Press again to return to 1st
speed (low speed) and travel speed lamp
turns off.
Travel speed always begins in 1st speed
when starting the engine.
Refer to page
55 , " Travel Speed Lamp."
Light Switches
0
L38028
When this switch is turned on while the
ignition switch is at
ON, the lights turn on as
follows:
Front light switch
O
... ............ Off
I. . ..... ..... ... . Instrument lights and front lights
turn on.
Tail light switch
O .
..... ..... ... . Off
1. ............... Tail lights turn on.
60
Wiper Switches (Option)
IMPORTANT: If no washer fluid is
discharged, do not operate the washer.
Doing so may damage the pump.
IMPORTANT: Operating the wiper with no
moisture
on the windshield will scratch
the glass. Apply water or washer fluid
when operating the wiper.
IMPORTANT:
In cold seasons, the wiper
blade may freeze to the glass. Operating
the wiper forcibly may damage the wiper
motor.
0
L38029
Front wiper switch
O
.. ... ..... ..... Off
I. ............... Wiper operates.
PUSH
... .... Washer fluid is squirted from the
nozzle while pressed, and stops
when released.
Rear wiper switch
O ............... Off
I. ............ ... Wiper operates.
PUSH
... .... Washer fluid is squirted from the
nozzle while pressed, and stops
when released.

Takeuchi TL250 Specifications

General

Engine Make	Yanmar
Engine Power	74 hp
Lift Height	3, 275 mm
Net Power	73.5 kW
Travel Speed - High	11.8 km/h
Hydraulic Pump Flow	92.5 L/min
Auxiliary Hydraulic Flow	92.5 L/min
Width	1, 980 mm
Engine Model	4TNV98
Travel Speed - Low	7.2 km/h