IMPORTANT SAFETY INSTRUCTIONS
27 TASCAM CD-GT2
Listening to CDs
When the guitar cancel function is ON, the icon at the top
of the screen appears in inverse.
Depending on the music, the guitar cancel function may not
reduce the recorded guitar sound sufciently. If this occurs,
changing the PART and RANGE settings might make the
reduction more effective. Listen to the music as you adjust the
settings to achieve the best effect.
Depending on the recording of the music, reduction of
the guitar part with this function may not be possible.
PART
Adjust this setting to match the stereo position of the sound
that you want to reduce between LEFT 10 and RIGHT 10.
The initial setting is CENTER.
RANGE
Select MIDDLE or ALL for the range of sound reduction. The
default setting is MIDDLE.
Loop playback
With this function you can continuously repeat the playback of
a selection that you make (loop playback).
1 Press the IN/OUT key during playback to set the point
when you want to start loop playback. The current
position is set as the IN point, and the symbol
appears below the playback position display bar at
that point.
2 Press the IN/OUT key at the point when you want loop
playback to stop. The current position is set as the
OUT point, and the symbol appears below the play-
back position display bar at that point. After setting
the OUT point, loop playback begins between the IN
and OUT points.
The play mode icon appears on the left of the display.
To stop loop playback, press either the LOOP key or the
IN/OUT key.
If you press the LOOP key, the loop interval settings are saved,
and if you press the LOOP key again loop playback of the set
interval begins again.
If you press the IN/OUT key, the loop interval settings (IN
point and OUT point settings) are canceled.
To Next Page
Loading...
