Tascam CD-GT2 - Effect Module Details; Chorus, Tremolo, Vibrato Modules; Wah, Pitch Shifter, Reverb, Delay

IMPORTANT SAFETY INSTRUCTIONS
43 TASCAM CD-GT2
Effect module parameter list
Module Effect Parameter Details Range
Chorus
(CHO)
Adds a slightly detuned sound to create a wide, ensem-
ble-like tone. This effect was popular in 70s hard rock
and fusion.
DPTH
Adjusts the modulation depth 0–30
MIX
Adjusts the amount of the effect 0–20
Tremolo
(TRM)
Creates a cyclical variation in the volume. A sound like
a rotary speaker can be achieved by combining it with
delay.
SPD
Adjusts the speed of the effect. 0–30
MIX
Adjusts the amount of the effect 0–20
Vibrato
(VIB)
Creates a cyclical variation in the frequency for a regu-
lar pitch variation.
SPD
Adjusts the speed of the effect. 0–30
MIX
Adjusts the amount of the effect 0–20
Autowah
(WAH)
Creates a sound like a wah pedal that is great for funky
sounds. Vary your picking force when using this effect.
SENS
Adjusts sensitivity to picking force 0–30
MIX
Adjusts the amount of the effect 0–20
Pitch Shifter
(PIT)
Changes the pitch of the input signal and can be used
to create a doubled lead sound, for example. Set PIT
between 6 and 17, or –6 and –17, for semitone changes.
PIT
Adjusts pitch in semitones (±6–17)
or in smaller intervals (–5 to +5)
±17
MIX
Adjusts the amount of the effect 0–20
Reverb
(REV)
Creates reections, like the echoes in a stone church, to
give the sound greater width. Surf rock uses this effect
extensively.
TIME
Adjusts the reverberation time 0–25
MIX
Adjusts the amount of the effect 0–20
Delay
(DLY)
Adds echoes to the sound. Adjust the TIME and turn the
MIX level up for a rockabilly sound.
TIME
Adjusts the delay time 0–99
MIX
Adjusts the amount of the effect 0–20