EasyManuals Logo

Taski swingo 2500 Instructions For Use

Taski swingo 2500
Go to English
360 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
65
Cleaning start
Battery capacity - end of operational readiness
If none of the bars in the battery indicator light up:
the brush unit and the suction nozzle are lifted off the floor
after 10 minutes.
the suction unit is switched off after 10 sec.
there are 10 more minutes remaining for driving the
machine to the battery charger before it switches off com-
pletely.
Recycling operation (option)
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Replenishing cleaning solvent
Notice:
Always calculate and select the lowest lev-
el that is sufficient for good cleaning re-
sults. Thus you will optimize power
consumption and increase the service life
of the machine.
Using the direction selector lever,
choose your travel direction ([1] for-
wards / [2] backwards).
If the machine is switched on and the
operator is sitting on the driver seat,
the machine starts moving as soon
as the gas pedal is depressed. If se-
lected, the brush unit is started and
the cleaning solution supply is open.
The speed is controlled by the posi
-
tion of the gas pedal.
Attention:
When working in heavily furnished or nar-
row zones, the slow approach ON/OFF
button must be pressed. (Display lights up)
The maximum working speed is reduced,
and thus so is the risk of accidents.
Pressing this button once more will
override this restriction, and the dis-
play disappears.
If none of the bars in the battery indi-
cator light up, you must drive the
scrubber dryer to the battery charger.
Notice:
The battery level indicator provides infor-
mation on the available operating time.
1
2
2
1
Attention:
The recycling system is not permitted for
high hygiene requirements (e.g. hospitals,
food-processing companies, canteens,
etc.).
Recycling operation is only recommended
for slight to medium soiling.
Remove the key and actuate the stopping brake.
Fold the driver seat forwards and open the tank cover.
Take out the recycling filter from the fresh water tank (Flex-
tank).
Insert the recycling filter into the recovery tank.
Attention:
Max. permissible water temperature 60°C/
140°F.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.
Attention:
The floor surface may be damaged when
working without cleaning solution.
A signal is sounded if the cleaning
solution indicator lights up.
Switch off the machine (key switch) and actuate the stop-
ping brake.
Fill water into the fresh water tank (Flextank), see page 63.
Notice:
As soon as the fresh water tank (Flextank)
is filled, the cleaning solution indicator
lights up
The cleaning solution empty indica-
tor is reset approx. 5 seconds after
actuation of the gas pedal.
EN

Table of Contents

Other manuals for Taski swingo 2500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taski swingo 2500 and is the answer not in the manual?

Taski swingo 2500 Specifications

General IconGeneral
BrandTaski
Modelswingo 2500
CategoryFloor Machine
LanguageEnglish

Related product manuals