66
Draining dirty water
Recovery tank full display:
End of operation
Removing and cleaning the squeegee
Draining and cleaning the recovery and fresh water tank
(Flextank)
Proceed as follows:
• If the Recovery tank display lights up,
the cleaning program is interrupted,
the suction nozzle is lifted and the
suction unit is switched off.
• Drain the recovery tank, see page 66.
Notice:
In case of frothing in the tank, the recovery
tank display also lights up.
• Press the Cleaning solution ON/OFF
button.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
• Press the Brush drive ON/OFF but-
ton.
The brush unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Press the suction unit ON/OFF but-
ton.
The suction nozzle is lifted automati
-
cally.
The suction motor is still on for 10
seconds.
• Remove the key and actuate the stopping brake.
• Remove both suction hoses from the suction nozzles.
• Compress the position locks. The
suction nozzle is released and can
be removed from the suction nozzle
holder.
• Clean the suction nozzle under running water using a
brush.
• Assemble the suction nozzle to the nozzle/hose holder.
Notice:
Only cleaned and intact blades ensure op-
timal suction results!
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment of the
cleaning solution manufacturer must be
observed.
• Remove the key and actuate the stopping brake.
• Remove the drain water hose from
the holder.
• Hold the hose level with the edge of
the tank, with its opening facing up-
wards. Open the red cover, slowly
lower the hose end to the drain and
empty the recovery tank.
• Lift the fresh water tank (Flextank), put it into the recovery
tank at the lowest point and discharge it.
• Remove the empty fresh water tank (Flextank) from the re-
covery tank and thoroughly rinse it with clean water.
• Thoroughly rinse the recovery tank with clean water.
• Remove the solids filter (yellow) and
thoroughly drain and rinse it under
running water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Take out the intake filter and remove
the dirt with a cloth or a soft brush.
Attention:
Clogged suction filters may impair the suc-
tion performance.
Clogged intake filters may reduce the
amount of cleaning solution.
• Mount the dirt sieve (yellow), the fresh water tank (Flex-
tank), suction filter and intake filter.
• Put the drain hose into the holder.
To Next Page
Loading...
Need help?
General
