18
K580M
6 obstacle detected (only with dip 11 ON);
Make sure there are no obstacles across the path of the gate and that it slides
smoothly;
Learning process not completed;
Repeat the Learning process procedure;
Learning procedure in progress;
(duration 30 sec.)
Only when powered up: wrong power supply frequency (50 Hz default set-
ting);
RESTORING AUTOMATIC OPERATION
Should the gate needs to be operated manually, use the release system. After a manual operation:
433.92 MHz BUILT-IN RADIO RECEIVER
4RP) which can be set on both the two channels as desired.
-
-
for about 3 seconds without performing any memorisation.
procedure of remote programming of the new transmitters. Follow the procedure written on the in-
ENGLISH