22
Models 150, 152, 162, 168Operating Procedures
Step 15
Lay the feed tube(s) in the bottom of the mix hopper(s).
Sanitizing
Step 1
Prepare an approved 100 PPM sanitizing solution (ex-
amples: Kay- 5R or Stera- SheenR). USE WARM
W ATER AND FOLLOW THE MANUF ACTURER’S
SPECIFICATIONS.
Step 2
Pour one gallon (3.8 liters) of the sanitizing solution
into the hopper and allow it to flow into the freezing
cylinder.
Step 3
While the solution is flowing into the freezing cylinder ,
brush- clean the mix hopper , mix level float stem, mix
inlet hole, and feed tube.
Figure 29
Figure 30
Figure 31
Step 4
Press the reset button.
Figure 32
Step 5
Place the power switch in the “WASH” position. This
will cause the sanitizing solution in the freezing
cylinder to be agitated. Allow it to agitate for five
minutes.
Figure 33
To Next Page
Loading...
