How to troubleshoot a Taylor Freezer that will not run?
If your Taylor Freezer unit isn't running, first check the breaker panel. Also, examine the power cord plug, wall receptacle, and terminal block to ensure they are functioning correctly.
What to do if my Taylor 220 Freezer product is not freezing?
If the product is not freezing in your Taylor Freezer, ensure the timer control is properly set or replace it if defective. For air-cooled units, clean the condensers monthly. Also, make sure the control switch is in the AUTO position for compressor operation.
Why is my Taylor 220 unit off on high head?
If your Taylor Freezer is off on high head, replace the condenser fan if it is defective. Clean the condenser if it's dirty, and ensure there's at least 6” of air clearance around all sides of the unit.
How to fix excessive mix leakage in the rear drip tray of Taylor 220?
If there is excessive mix leakage in the rear drip tray of your Taylor Freezer, install or replace the seal on the beater drive shaft. If that doesn't solve the issue, replace the bearing, and make sure to lubricate properly.
What causes the beater motor not to run in AUTO mode on a Taylor 220?
If your Taylor Freezer beater motor will not run in the AUTO mode, repair any loose or broken wires at the beater motor contactor. If the wiring is intact, replace the contactor.
Why won't the compressor run in AUTO mode on my Taylor 220 Freezer?
If your Taylor Freezer compressor will not run in the AUTO mode, repair any loose or broken wires at the compressor contactor. If the wiring is intact, replace the contactor.
How to improve poor ejection in Taylor 220?
If you're experiencing poor ejection with your Taylor Freezer, try using less time to run the batch to avoid over-refrigeration. If that doesn't work, increase the pre-charge. Also, ensure the beater is rotating clockwise.
What to do if Taylor 220 has no ejection?
If your Taylor Freezer is not ejecting, allow the unit to cool if it is off on high head PSI. Also, repair any loose or broken wires at the beater relay. If the wiring is intact, replace the rocker switch or the door switch.
Why Taylor 220 Freezer has no beater operation in AUTO position?
If the beater is not operating with the control switch in the AUTO position on your Taylor Freezer, first plug the unit into a wall receptacle. If it is already plugged in, check if the circuit breaker is off or the fuse is blown and turn the breaker on or replace the fuse. As well, check the rocker switch. If the problem persists, check for loose or broken wire at compressor contactor and repair it, allow the unit to cool if it is off on high PSI cut out, put the freezer in the OFF position to allow the unit to cool if it is out on reset, and secure the door for freezer operation if it is open.
How to decrease overrun in Taylor 220 Freezer?
If the overrun is too high in your Taylor Freezer, ensure there is enough mix in the freezing cylinder when priming the machine by following priming procedures. If that doesn't solve the issue, adjust the temperature control accordingly. Also, avoid leaving the unit in EJECT position too long after drawing product.
To Next Page
General
