Taylor 342 - Page 30

6-6
OPERATING PROCEDURE
Models 340, 341, 342
Operating Procedure
6
Figure 6-22
7. Move the draw handle to the back position to lock the
ice buster in place.
Figure 6-23
8. Turn the door right side up. Remove the draw valve
handle. Install it on the other side, through the longer
slot and into the draw valve hole.
Figure 6-24
9. Insert the valve handle pin. Turn the pin and the draw
valve handle until the pin drops completely into place.
Note: While turning the draw valve handle, it may
be necessary to pull the draw valve handle back
slightly to allow the pin to fall in place.
Figure 6-25
10. Place the O-ring onto the prime plug and lubricate.
Figure 6-26
11. Screw the prime plug into position on the front of the
door.
101607
101608
101609
101610
11145
Apply the appropriate
Taylor approved food safe lubricant.