OPERATING PROCEDURE
6-7
Models 340, 341, 342
Operating Procedure
6
Figure 6-27
12. Place the large rubber gasket into the groove on the
back side of the freezer door
.
Figure 6-28
13. Slide the white, plastic front bearing onto the bearing
hub, making certain that the flanged end of the
bearing is resting against the freezer door. Do not
lubricate the door gasket or front bearing.
Figure 6-29
14. Position the freezer door onto the four studs on the
front of the freezing cylinder and push the door into
place. Install the four handscrews onto the studs and
tighten them equally in a crisscross pattern to ensure
that the door is snug. Do not over-tighten the
handscrews.
Note: If the freezer door does not fit into place
easily, position the open end of the beater assembly
in the 11 o'clock position.
Figure 6-30
15. Position the torque arm by inserting it down into the
hole on the torque rotor which protrudes from the
door. Verify proper installation by moving the torque
rotor back and forth to be sure it moves freely.
Figure 6-31
16. Slide the long drip pan into the hole in the front panel.
To Next Page
Loading...
