Taylor 428 - Model 428 Specifications

4
Introduction
Model 428
Model 428 Specifications
Freezing Cylinder
One, 7 quart (6.6 liter) capacity.
Mix Hopper
One, 20 quart (18.9 liter) capacity
Refrigerated and insulated
Beater Motor
One, 1/2 HP motor
Refrigeration Unit
One, approximately 3,600 btu/hr compressor
Refrigerant 404A
Electrical
One dedicated electrical connection is required. See
the electrical chart for proper electrical requirements.
Manufactured to be cord connected.
Electrical
One dedicated connection.
Total
Amps
Supplied with
NEMA Cord
115/60/1 Air 16.0 5-20P
220-240/50/1 Air 7.0 - - -
This unit may be manufactured with other electrical
characteristics. Refer to the local Taylor Distributor
for availability. (For exact electrical information,
always refer to the data label of the unit.)
Air Cooled
Clearance: 6” (152 mm) on both sides. It is
recommended to place the rear of the unit against
the wall. Minimum air clearances must be met to
assure adequate air flow for optimum performance.
Dimensions
Width: 13-1/2” (343 mm)
Depth: 32-1/2” (826 mm)
Height: 32-5/8” (829 mm)
Counter Clearance: Designed to rest on a plastic
pad directly on counter top.
Approximate Weights
Net: 221 lbs. (100.2 kgs)
Crated: 264 lbs. (119.8 kgs)
Volume: 22.8 cu. ft. (0.64 cu.m.)
Specifications are subject to change without notice.
This unit is designed and constructed to meet
stringent safety and sanitation requirements for
NSF, UL, and CSA.