Taylor 441 Operating Instructions

3-2
SAFETY
Models 441 & 444
Safety
3
• If the supply cord is damaged, it must be
replaced by an authorized Taylor service
technician in order to avoid a hazard.
Failure to follow these instructions may result in
electrocution. Contact your local authorized Taylor
distributor for service.
WARNING! DO NOT use a water jet
to c
lean or
rinse the unit. Failure to follow these instr
uctions may
result in serious electrical shock.
WARNING! A
v
oid injury.
• DO NOT allow u
ntrained personnel to operate
this unit.
• DO NOT operate the unit unless all se
rvice
panels and access doors are restrained with
screws.
• DO NOT remove any internal operating parts
(including, but not limited to, freezer door,
beater, or scraper blades), unless all control
switches are in the OFF position.
Failure to follow these instructio
ns
may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
WARNING!
T
his unit has many sharp edges
that can cause severe injuries.
• DO NOT put
objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
• USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very
sharp.
CAUTION! This
m
achine must be placed on a
level surface. Extreme care should be taken when
mov
ing for any reason. Two or more persons are
required to safely move this machine. Failure to comply
may result in personal injury or damage to the machine.
NOTICE! Clean
ing
and sanitizing schedules
are governed by your federal, state
, or local regulatory
agencies and must be followed accordingly. Please refer
to the cleaning section of this manual for the proper
procedure to clean this unit.
CAUTION! T
h
is unit is equipped with a
refrigerated cabinet, designed to maintain product
temper
ature at or below 41°F (5°C). Before replenishing
the mix supply, the product must be refrigerated at or
below 41°F (5°C). Failure to follow this instruction may
result in health hazards and poor freezer performance.
DO NOT ru
n
the unit without product. Failure to follow
this instruction can result in damage to the unit.
DO NOT obs
truct air intake and discharge openings. A
minimum of 3 in. (76 mm) air clearance on both sides of
the unit is required. It is recommended to place the rear
of the unit against the wall to prevent the recirculation of
warm air. Failure to follow this instruction may cause poor
freezer performance and damage to the machine.
For Indoor Use Only:
T
his machine is designed to
operate indoors, under normal ambient temperatures of
70°F to 75°F (21°C to 24°C). The machine has
successfully performed in high ambient temperatures of
up to 104°F (40°C) at reduced capacities.
Noise Level: Air
b
orne noise emission does not exceed
78 dB(A) when measured at a distance of 39 in. (1.0 m)
from the surface of the machine and at a height of 62 in.
(1.6 m) from the floor.
!
!

Taylor 441 Specifications

General

Brand	Taylor
Model	441
Category	Ice Cream Maker
Language	English