14
Models 60 & 62Operating Procedures
150626
Step 2
Before installing the beater assembly, inspect the
scraper blades and clips.
Check the scraper blades for any signs of wear or
damage. If a scraper blade is nicked or worn, replace
both blades.
Check the scraper blade clips to make sure they are
not bent and the slot is even for the entire length of the
clip. Replace any damaged clips.
Figure 6
If the blades and clips are in good condition, assemble
the blade and the clip. Place the rear scraper blade
over the two rear holding pins (knife edge to the
outside).
Figure 7
Holding the rear blade on the beater , slide it halfway
into the freezing cylinder. Install the front scraper blade
and the scraper blade clip over the front holding pins.
Slide the beater assembly the rest of the way into the
freezing cylinder.
Figure 8
Make sure the beater assembly is in position over the
drive shaft. Turn the beater slightly to be certain that
the beater assembly is properly seated.
Figure 9
Step 3
Install the torque rotor assembly. Assemble the torque
rotor by sliding the two o- rings on the front of the shaft
and lubricate them thoroughly to prevent leaking.
Place the white plastic guide bearing on the rear of the
rotor shaft. DO NOT lubricate the plastic guide bearing
Figure 10
To Next Page
Loading...
