15
Models 60 & 62 Operating Procedures
150626
Insert the torque rotor, plastic guide bearing end first,
making sure that it fits into the hole in the beater drive
shaft. Rotate it several times to check for proper
positioning.
Figure 11
Step 4
Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear:
door bearing, door gasket, draw valve, o- rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
Step 5
Install the draw valve. Lubricate the plastic spinner
bearing. Insert the plastic spinner bearing into the top
of the draw valve.
Figure 12
Slide the two o- rings onto the draw valve and lubricate
the draw valve.
Figure 13
Lubricate the inside of the door spout, top and bottom.
Insert the draw valve into the freezer door from the top.
It will be necessary to rotate the draw valve to the right
when assembling the door to the freezer.
Figure 14
Step 6
Place the large rubber gasket into the groove on the
back side of the freezer door. DO NOT lubricate the
gasket.
Figure 15
To Next Page
Loading...
