16
Models 60 & 62Operating Procedures
Slide the white plastic front bearing onto the bearing
hub, making certain that the flanged end of the bearing
sleeve is resting against the freezer door. DO NOT
lubricate the front bearing.
Figure 16
Install the door on the freezer by placing the torque
rotor shaft into the center hole of the freezer door .
Position the door on the four studs on the front of the
freezing cylinder.
Install the four handscrews onto the door and tighten
them equally in a criss- cross pattern.
Figure 17
Step 7
Install the drip pan. Slide the drip pan into the hole in
the front panel.
Figure 18
Step 8
Install the spinner housing. Snap the plastic spinner
housing onto the bottom of the door spout.
Figure 19
Lubricate the spinner blade shaft, and insert the
spinner blade from the bottom into the center of the
draw valve.
Figure 20
To Next Page
Loading...
