6-2
OPERATING PROCEDURES
Model C722
Operating Procedures
6
Figure 6-3
WARNING! Use extreme caution when
handling the beater assembly. The scraper blades are
very sharp and may cause injury.
6. Before installing the beater assembly, check the
scraper blades.
Check the scraper blades for any signs of wear or
damage. If a scraper blade is nicked or worn, replace
both blades.
Figure 6-4
If the blades are in good condition, place the rear
scraper blade over the rear holding pin on the beater.
Figure 6-5
Note: Scraper blades should be replaced every
3 months.
Note: The hole on the scraper blade must fit
securely over the pin to prevent damage.
7. Holding the rear blade on the beater, slide it halfway
into the freezing cylinder. Install the front scraper
blade over the front holding pin.
Figure 6-6
8. Before installing the beater shoes, check the shoes
for any nicks, cracks, or signs of wear. If any defects
are present, replace the beater shoes.
9. If the beater shoes are in good condition, install the
beater shoes.
To Next Page
Loading...
Need help?
General
